[Pw_forum] Example08 stop at Fermi surface calculation

lilonghua foursea at 163.com
Sun Jul 31 11:27:36 CEST 2011


Dear all,

I have searched the forum, but I didn't find any information that could help me. Therefore, I send my question.

In the case of Example08, I found the calculation always stop at the "running the Fermi Surface calculation ..."。I use "top" to watch and only "mpirun" command is runing, not "pw.x"! Further, I found that both the serial calculation with the default number of k-point(4913 in the example08) and the parallel calculation with less k-points for  FS are OK! 

So, I am very confused. Can anyone solve this problem? Thanks!
 
  Best regards,
Longhua Li
2011-07-31 				
----------------------------------------
lilonghua


More information about the users mailing list