[Q-e-developers] Error compiling PW/tools/dist.f using PGI 14.2

[Paolo Giannozzi]

Problem solved: no more than three days ago I had deleted 
that file (dist.f), because I was fed up of making a special
input file for it so I wrote a different version, dist.f90,
that does (almost) the same but reads input data in the PWscf 
format ...

P.
 !On Thu, 2014-02-27 at 22:51 +0000, Filippo Spiga wrote:
> Dear all,
> 
> I hit a error compiling using PGI version 14.2 ...
> 
> make[2]: Entering directory `/scratch/fs395/QE-SOURCES/espresso/PW/tools'
> if test -n "" ; then \
> 	( cd ../.. ; make  || exit 1 ) ; fi
> pgf77 -O3 -r8 -mp -c dist.f
> PGFTN-S-0083-Vector expression used where scalar expression required (dist.f: 83)
>   0 inform,   0 warnings,   1 severes, 0 fatal for dist
> PGFTN/x86-64 Linux 14.2-0: compilation completed with severe errors
> make[2]: *** [dist.o] Error 2
> 
> I suggest to set F77 to pgf90 instead of pgf77, a simple change in the configure has to be done. This will solves the issue (and everything compile perfectly). Should I proceed?
> 
> F
> 
> --
> Mr. Filippo SPIGA, M.Sc.
> http://www.linkedin.com/in/filippospiga ~ skype: filippo.spiga
> 
> «Nobody will drive us out of Cantor's paradise.» ~ David Hilbert
> 
> *****
> Disclaimer: "Please note this message and any attachments are CONFIDENTIAL and may be privileged or otherwise protected from disclosure. The contents are not to be disclosed to anyone other than the addressee. Unauthorized recipients are requested to preserve this confidentiality and to advise the sender immediately of any error in transmission."
> 
> 
> 
> _______________________________________________
> Q-e-developers mailing list
> Q-e-developers at qe-forge.org
> http://qe-forge.org/mailman/listinfo/q-e-developers

-- 
 Paolo Giannozzi, Dept. Chemistry&Physics&Environment, 
 Univ. Udine, via delle Scienze 208, 33100 Udine, Italy
 Phone +39-0432-558216, fax +39-0432-558222