[Wannier] How do I change the interpolation mesh

[Christoph Wolf]

The parameter you are looking for is most likely " kmesh"  from page 99 of
the user guide

Dimensions of the uniform interpolation k-mesh (one or three integers)

On Tue, May 1, 2018 at 8:25 AM, 刘建 <b12130012 at hnu.edu.cn> wrote:

> Hi,
>
>   I'm following the wannier90 tutorial example 16, it goes well. However ,
> in the "Further ideas" , it mentions that "Change the interpolation to a
> 60×60×60 mesh and run again postw90" . I'm confused here. How can I change
> the interpolation to a 60×60×60 mesh? I was tried to change the mp_grid
> from 4 4 4 to 60 60 60 in  Si.win. Apparently it didn't work, failed to
> read Si.eig , because  the kpoints changed. Do I have to redo the step 2 ,
> run a nscf with a k mesh 60 60 60 ?
>
> best regards
>
> Jian Liu
> _______________________________________________
> Wannier mailing list
> Wannier at lists.quantum-espresso.org
> https://lists.quantum-espresso.org/mailman/listinfo/wannier
>



-- 
Postdoctoral Researcher
Center for Quantum Nanoscience, Institute for Basic Science
Ewha Womans University, Seoul, South Korea
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.quantum-espresso.org/pipermail/wannier/attachments/20180501/c2ee90d5/attachment.html>