[Pw_forum] How to deal with the error (bad termination exit code: 9) in phonon calculation?

Axel Kohlmeyer akohlmey at gmail.com
Thu May 28 13:28:30 CEST 2015


On Thu, May 28, 2015 at 7:22 AM, liyincumt at gmail.com
<liyincumt at gmail.com> wrote:
> I was using mpich2 to run parallel version of pw.x and ph.x. I think this
> error information was generated by my mpich2. In this case, where could I
> reach the real error information?

you have to talk to the people that operate the machine that you are
running on.
i have seen this kind of termination most often when people submitted
a calculation to a batch system without reserving a suitable amount of
wall time and then the calculation was forcibly terminated by the
batch system. you should see that in the batch system outputs that
correspond to your calculation, if that is what happened to you.

axel.

>
> Best Regards,
> Dr. Yin Li
> Department of Biophysics,Medical School, University of Pecs,
> No.12 Szigeti Street, Pecs, H-7624, HUNGARY
> Phone: +36-72-535271/36271
>
> _______________________________________________
> Pw_forum mailing list
> Pw_forum at pwscf.org
> http://pwscf.org/mailman/listinfo/pw_forum



-- 
Dr. Axel Kohlmeyer  akohlmey at gmail.com  http://goo.gl/1wk0
College of Science & Technology, Temple University, Philadelphia PA, USA
International Centre for Theoretical Physics, Trieste. Italy.



More information about the users mailing list