[Pw_forum] parallel environment not found

[Mahmoud Payami]

Dear Paolo,
Thank you very much for your comment.
When I run interactively using an in-file on a single processor, the result
is:

the same lines when one uses pw.x; including the following message:
**Address Error**

For information I inform that as you (before)and Gerardo(now) suggested, I
have configured with "--enable-shared".

Best regards,

Mahmoud


> On Tuesday 26 October 2004 18:21, Mahmoud Payami wrote:
>
> > Now trying to run example01, the computer sleeps and the only
> > nonempty file  in /results is si.scf.dav.out [...]
>
> check first with just one processor. Try to run a single job interactively
> (with the output on the terminal, not on a file). Check if input
redirection
> works (sometimes it doesn't with MPI libraries that are not properly
> configured)
>
> P.
> -- 
> Paolo Giannozzi             e-mail:  giannozz at nest.sns.it
> Scuola Normale Superiore    Phone:   +39/050-509876, Fax:-563513
> Piazza dei Cavalieri 7      I-56126 Pisa, Italy
> _______________________________________________
> Pw_forum mailing list
> Pw_forum at pwscf.org
> http://www.democritos.it/mailman/listinfo/pw_forum
>
>